CCT-3300E : Conductometer 1 relay and 4-20mA current output, 24V power supply

• A distinctive feature of the Create CCT-3300 model conductometer is that this controller allows you to set two points (lower and upper) upon reaching which the actuator relay will operate. The converter has an analog current output of 4-20mA. 
• The device is completed with one of three electrodes and each electrode is designed for a specific range of conductivity measurement (see Additional photo below - Table of electrode selection for the measurement environment):
• 0-19.99; 0-199.9μS / cm (0.1cm -1  electrode)
• 0-19.99; 0-199.9; 0-1999μS / cm (1.0 cm -1  electrode)
• 0-199.9; 0-1999μS / cm; 0-19.99mS / cm (10cm -1  electrode)
• Measuring electrodes, variants of execution (the model comes with an electrode model CON-1134-13, cell size 1.0cm, plastic case):
• 0.1cm -1  316L stainless steel case steel, platinum electrode, 1/2 in. male threaded connection
• 1.0cm -1  plastic case, platinum electrode, 1/2 in. External screw connection
• 1.0cm -1  stainless steel, 1/2 in. External threaded connection
• 10.0 cm -1  teflon, tech. Platinum 3/4 ”Male Threaded

Specifications:

• Electrode cable length: 5 meters (max. Elongation up to 20m possible)
• Working pressure: 0-0.5MPa
• Operating temperature: 0-50 ° C
• Automatic temperature compensation
• Accuracy: 1.5% of full scale
• Stability: ± 2 × 10 -3 (full scale) / 24 hours
• Max load resistance: Max. DC @ DC 9V
• Max load: AC 230V / 5A (without electromagnetic induction)
• Control Model: ON / OFF of two output contacts (Relay)
• Isolated analog current output 4-20mA, resistance 0-400Ω, accuracy ± 0.1mA
• Power supply: 24V ± 15%
• Required power: 2W
• Environment: Temperature: 0-50 ° C; Humidity: ≤85% RH
• Dimensions: 48 × 96 × 100mm (height × width × depth)